PEEK - Material Guide | Craftcloud®

Material

PEEK

FDM PEEK is a premium engineering thermoplastic that combines exceptional heat resistance, strength, and chemical resistance with genuine biocompatibility. It is used where metal replacement or medical-grade performance is required.

Manufacturing processes

FDM

About

PEEK (polyether ether ketone) is one of the highest-performing thermoplastics available for FDM printing, with a glass transition temperature around 143 °C and a melting point above 334 °C – well beyond ABS, PC, or nylon composites.

Unlike many reinforced composites, PEEK combines high strength and stiffness with genuinely good impact resistance and wear resistance, rather than trading one for the other. It offers outstanding resistance to acids, bases, and organic solvents, is inherently flame retardant with very low smoke generation, and is biocompatible enough for use in medical implants and surgical instruments. These properties come at a significant cost premium over standard engineering plastics.

PEEK suits aerospace components, medical devices, and industrial parts like bearings, seals, and gears that need to perform reliably in extreme conditions.

Technical Details

Property Value
Accuracy ±0.3% (lower limit of ±0.2 mm)
Density 1.3 g/cm³
Min. wall thickness 1 mm

Technical Properties

Download datasheet

Property Value
Tensile strength 98 - 100 MPa
Tensile modulus 3720 - 3738 MPa
Tensile elongation 28 - 40%
Flexural strength 130 - 170 MPa
Flexural modulus 2700 - 4200 MPa
HDT (0.45 MPa) 140 - 152°C
Default layer height 0.2 mm
Default infill 20%
Embossing (min.) 0.5 mm
Engraving (min.) 0.5 mm
Warping risk High
Maximum printing dimensions 500 × 500 × 700 mm

Finishes

Properties

Colors

Natural